Drill Bits by Cir-Kit at B & J Miniature Creations

These tiny bits are helpful aids for installing any of the various Cir-Kit Concepts' wiring and lighting fixtures. Their use greatly enhances and simplifies installation in all types of wood.

The No. 55 bit is used in making starter holes for the CK1023-6 Spring-Loaded eyelets and for the small hollow eyelets used at tape run interconnect points. Measures .052" in diameter.

The No. 66 wire-size bit is used principally in the CK104 kit for making the proper size hold for "fixture" and "circuit" type wires. Measures .033" in diameter.

The 1/32" bit provides the proper size hole for wall sconce wires. This hole allows the pulling of sconce wires through a wall and electrically connecting them into a conductive tape run on the opposite side of a wall. (The wires are inserted into copper strip holes made with either a push pin or No. 70 bit)

The No. 70 bit may be used in place of a push pin for making .028" holes in copper tape runs
This size hole allows easy bradding of either a 12-volt GOW or wire terminal bulb into a conductive tape run.

The No. 75 bit allows drilling of small .021" holes at tape juncture points for easy insertion of 1/8" brads in hardwood or Masonite structures. (May also be used for outlet and switch nails.) The drilling of holes simplifies brad installation and assures a tight electrical fit between the brad and copper strip.

All bits may be used with either a 1/4" electric drill or the CK201 Mini Drill.